Honda CBR XX Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Hey guys,

I finally found a cheap enough Wing Rack 2 6 months ago, drove hours to get it, the next day I tried to install it and I felt like I couldn't without scratching the bike badly. So I stopped and I haven't done much with my bike since as it's been cold lol

As it's almost time to get her back out again, do I need to take the Wing Rack apart and attach it to the bike in pieces and then together?
 

· Administrator
Joined
·
9,763 Posts
No lay a towel over the tail cowl. Remove the nuts on the rear exhaust hangers and the rear grab rail. Then you should be able to slide the rack in from behind and install the mounting hardware. Leave everything loose until all the bolts and nuts are installed then tighten everything up. You might have to move the rack around some as things are securing to prevent binding. Once the mounts are torqued down check clearances. You may have to loosen up some of the frame mounts to get the clearances even. Once you do then you won't need to adjust then again.
Once you've got it all right then installation and removal will be much easier.
 
1 - 3 of 3 Posts
Top