Honda CBR XX Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter #1
So a snapped master link has plagued me with several problems. Needed new lower case due to losing all three mounting bolt locations on sprocket /slave cylinder cover (yeah not just the cover!) Unfortunately im in between a financial rock and hard place so thats out of the question. Fabricated 2 alluminium brackets out of what i found in a buddys garage and now i bellieve will work but i think the seals went out in my master. It wont bleed down and seems to be sucking air somewhere. But when i got new rivet link on i found through dissasembly and reverse, 4 times now, it does fine 1st to 2nd but going into 3rd or 4th and u get stuck. Long story short, i broke the little titty off the center fork trying to bend back. I got some factory cans, forks with lowers and a seati could trade
 

·
Play, it makes life fun
Joined
·
1,813 Posts
So what do you need? The cover over the front sprocket and the clutch master cylinder up on the left clip on?

Sent from my SM-N960U using Tapatalk
 
1 - 2 of 2 Posts
Top