Honda CBR XX Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
548 Posts
Discussion Starter #4
Not sure but if you tack welded a little lug on it you could surely make it less severe and even with as bad as that looks I cannot imagine it not flowing way more air than a stock exhaust.
Probably stainless steel Or?? so may have to pull it with your truck winch lol

Very expensive set-up new, my 2 slip ons for my ZX were just under a grand all said and done.
 

·
Registered
Joined
·
39 Posts
The way to fix those dents is to use plumber plugs from the hardware store, pump about 10 pounds of air pressure in the tubes, then take a torch and heat the dents until it's red hot, as you heat you will see the metal move, keep the heat on the low spots until they aren't low anymore.
 
1 - 5 of 5 Posts
Top