Honda CBR XX Forum banner

Engine rebuild!!!

1K views 2 replies 3 participants last post by  TigreST 
#1 ·
I posted a thread earlier about my bird not starting. It was the result of a valve and piston meeting in cylinder #1. (I was not invited lol). Anyway, since then I have had my cylinder honed and bought a cylinder head, piston, and gasket kit. Now I need new piston rings and bearings for my connecting rods, crankshaft, and cam shafts. Where can I find these parts? My connecting rods are labeled C1.
 
#2 ·
Download the manual,I have an F.I. manual and it's on page 11-8,11-9 for the rod bearings,basically you need the codes on the left end of the crank or measure the crank o.d. for each rod.Sometimes you can still see the colour code mark on the old bearing too.The crank info is in the next chapter pg 12-7,12-8.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top