Honda CBR XX Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
93 Posts
Discussion Starter #1
Hi everyone. Im losing fluid in my clutch master cylinder so I've got a new set of seals for the slave cylinder. I've never done this before so could anybody give me a quick run down how to do it. Many thanks ?
 

·
Registered
Joined
·
2,289 Posts
Hi everyone. Im losing fluid in my clutch master cylinder so I've got a new set of seals for the slave cylinder. I've never done this before so could anybody give me a quick run down how to do it. Many thanks ?
Take it off the bike. Blow some compressed air in to pop out piston.
Clean piston and and housing with fine steel wool to remove varnish.
Wipe down with dot 4 fluid, re-install and bleed.

Clean the old chain lube from housing and push rod while there.
Just did this the other week.

STex
 

·
Registered
Joined
·
93 Posts
Discussion Starter #3
Thanks....so do I take off the sprocket casing or just unbolt the clutch part ?
 
1 - 5 of 5 Posts
Top