If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed.
That would interesting if all the ducks lined up
STAY ALIVE BE DROPBEAR AWARE.
It looks close and would be a nice looking conversion although I'm guessing if you wanted new rather than finding one from a breakers it would be very expensive? .
I appreciate this is an old thread but it's been on my mind since I read it.
So I got a cheap top yoke from the bay to physically test it.
I'm glad to say that it fits perfectly, although the forks popping out the top might prove to be a clearance problem, I can't test that as you can see I don't have the handlebar saddles or a handlebar for that matter.
Perhaps this set up would open up options for some of the shorter 43mm forks to be used, as you could surely drop the forks through the clamps by 37mm without the clip ons on?
Sent from my Nokia 5.1 using Tapatalk
Now where have i seen those forks before?
Why are they so low on your forks. Looks like a lot of forks sticking out must turn sharp and lean forward quite a bit?
In that case you could afford to lift it abit putting the forks through abit to give you some clearance. I have had my clipons only half attached before sticking over the of fork ends but didn't trust them not to come loose at 299 lol. Thanks for the ideas like to see the finished product.