Undertail LED wiring trouble help. - Discuss Undertail LED wiring trouble help. on CBRXX, the ultimate on-line community for Honda motorcyclists. Read it in Body / Paint / Electrical / Lights. (Discussion of Honda CBR 1100 XX Super Blackbird Bodywork, Seats, Seat Cowls, Paint, Windscreens, Electrical System, and Lights.)

fzrcbrklxrider · 06-04-2007, 7:10 PM

Hi,
I finally go my undertail installed & it look's great but I have some wiring problem woes

My brake light's flash when the blinker is activated ? I have installed 2 load resistor's one for each side. Someone on the "other" forum mentioned the brake light's were tied into the blinker's some how, but That cant be I didnt have this problem before with the halogens. Any advice or help appreciated. I really need specific instruction's as to where each wire goes. I have tried many combination's with the same result.

2 LED brake's light's consisting of 3 wire's each 1-ground 1-runningLight 1-braking

2 LED turn signal's consiting of 2 wire's each 1-gound 1-power

Beondwacko · 06-05-2007, 8:24 AM

Something is bassackwards in there. Disconnect everything , ID all your supply wires and start from scratch. You might even want to pull off the tail cowling to make everything reachable and easy.

06-05-2007, 8:24 AM	#2
Beondwacko Join Date: Nov 03 2006 Location: West Palm Beach, Florida Posts: 165	Re: Undertail LED wiring trouble help. Something is bassackwards in there. Disconnect everything , ID all your supply wires and start from scratch. You might even want to pull off the tail cowling to make everything reachable and easy.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
LED kit for Radar Detector	N1K	Riding Gear / Luggage / Electronics	4	05-12-2007 11:20 PM
Hugger and undertail not agreeing	billypf	Body / Paint / Electrical / Lights	21	05-05-2007 9:27 PM